MiniMag Problem !! Need Help

Collapse
X
Collapse
 
  • Page of 1
  • Time
  • Show
Clear All
new posts
Previous template Next
  • Experenced Newbie
    Registered User
    • Oct 2002
    • 3
    #1

    MiniMag Problem !! Need Help

    I have a problem with my Minimag I can't figure out ! I have an airleak coming form the on/ off valve. I have changed all the o-rings and have re-teflon taped the whole gun and all the fittings but still leaks !! Someone told me that the on / off could be scratched would that effect it that much for it to leak ?? Get back at me laters
    Tags: None
    • athomas
      Of course it works-its AGD
      • Jan 2002
      • 8039
      #2
      When you install new o-rings in a mag, make sure you use plenty of good quality airtool lubricant. This will help to provide a good seal. Dry fire the gun with the barrel off to blow out any excess oil. This will probably solve your leak out of the on/off assembly. The on/off pin is stainless steel and its pretty tough so I doubt it is scratched.
      Except for the Automag in front, its usually the man behind the equipment that counts.

        Comment

        • Experenced Newbie
          Registered User
          • Oct 2002
          • 3
          #3
          Is there anyway that you can e-mail me a picture of the mini-mag valve ( A picture that shows every part and describes what it does ) I have had mine for awhile and have lost the movie that comes with it !! I am also looking in to getting a 2 fingered, electronic tigger and suggestions ?

            Comment

            • athomas
              Of course it works-its AGD
              • Jan 2002
              • 8039
              #4
              Here is the online manual for your valve.

              http://www.airgun.com/downloads/valveexplodedview.pdf
              Except for the Automag in front, its usually the man behind the equipment that counts.

                Comment

                • Experenced Newbie
                  Registered User
                  • Oct 2002
                  • 3
                  #5
                  Thanx, YOu have been tons of help ! Now I will try to figure out what is worng with this thing ! I already see that I might be missing some parts or have different ones in my gun !! Thank You once again !!
                  P.S. If this dosen't work Is it possible for me to send my valve in so your tech's can take a look at it ??

                    Comment

                    • athomas
                      Of course it works-its AGD
                      • Jan 2002
                      • 8039
                      #6
                      You should be able to get your mag valve working. The beauty of the mag is is simplicity. In extreme cases of failure, when you can't seem to find the solution, call AGD and arrange to send the valve to them for repair. AGD tech and customer service is excellent.

                      We should be able to help you with most problems right here in this forum. If after you replace/install the proper o-rings in your valve and it doesn't funtion as it should let us know and we'll offer our opinions and expertise.

                      Good luck and keep us posted on your progress.
                      Except for the Automag in front, its usually the man behind the equipment that counts.

                        Comment

                        Previous template Next
                        Working...