Help please...I just bought a used warp and its not working

[edhu]

i've done searches and stuff and have looked at the classic thread bout setup and the online manual.

but still not working.
my left jumpers i have two on.
and for the right..i have it on the bottom one.

i have a powerfeed mag with a retro valve and lvl 10 as upgrades.

this warp came with a on/off switch and green LED to tell whether its on or not. I don't know if this is standard or a mod. But the light does turn on when switched.

Any suggestions? Can someone fix this for me?

[edhu]

here's a pic

[Dayspring]

#1- The on/off is a mod. I had it done to mine as well.

Meanwhile, back at the Ranch...

Well, with the sensor adjuster in that position, it should run like crazy...

1) Are they fresh batteries?
2) Make sure there aren't any broken connections either between the on/off & LED mod and the rest of the warp (board & motor) or the board and the motor.
3) If you have a voltage tester, hook the battery up and turn it on. Put the tester leads on the motor connectors and see if it's getting any juice. Do the same to the board if you can get at it. (depending on the model of tester, you may be able to check and see if there's a broken connection by using the probes on the battery connector)
4) Make sure there aren't any open wires that could be causing a short.

This should get you a few answers and give us some more info to try and diagnose your problem.

BTW- who did your mod wiring? Does the seller know who it was? Maybe they can get you in touch with the mod-er.

[edhu]

I bought it bout a month ago off someone on this board. I can't remember who it is right now. But I bought his RT valve as well. And that had a problem with it as well, so i'm not sure so much about this warp feed.

anyway, i'll check all the connections.

thanks for the help.