Just got my MAG NEED HELP!!!!!!
I just got a classic standard feed mag. Is there any way that i could get a vertical adapter, because on the front where the adapter is supposed to go there is no hole for the screw. PLEASE HELP ME!!!!!!
-Cockr
-Cockr
-
-
if you remove the body fron the rail. there should be a hole @ the barrel end that is not thru the rail. you will need to make it a thru hole.Originally posted by dano_____ -
Just punch the front hole out using a hole punch.Except for the Automag in front, its usually the man behind the equipment that counts.Comment
-
So there is a hole in the frame, just you have to poke it out from the inside??? Right?!?!
-CockrComment
-
There is a pre-drilled hole in the body rail. It goes from the top (the side that touches the body) of the rail almost all the way through. Punch out the very thin layer of Al in the bottom of the hole and you'll be all set."Relax. Don't worry. Have a Home Brew."
-Charlie Papazian
Feedback: http://www.automags.org/forums/showt...threadid=40134Comment
Comment