just wondering...
-
-
I don't know... Most gas throughs are screw in are they not? In which case it wouldn't work. The RT Pro grip is held in there by 2 screws.
If you could find one that fit, Yes, it is possible. Run from the bottom line ASA to the gas-through then from the gas through to the valve. (You'd be adding one more piece of tubing to the mix instead of just one) -
POW!
Yes, you can add your own vert whatever dohickey you want to.
The stamped metal is held on by 6 screws. These are VERY easy to strip so push down hard on the allen wrench and keep from taking them on and off.
Once the stamped metal is off, there are 2 screws attaching the foregrip to it. Easy to remove.
On the rail, once removed from the body has a pre-drilled recess in it. This is where a vertical adaptor goes. You can use a punch tool. I didn't have one handy so I found a spare allen wrench of the right diameter and punched it out.
I just threw the foregrip back onto the rail without the extender thing with just one screw.
One thing to keep in mind is don't get any foregrips or regulators that are too long if you have a drop forward.
Good luck!Comment
Comment