warp feed mounting bracket

[paintballrulzs]

Well i need a mounting bracket for a warp feed where can i get one and how much? thanks

[Dubstar112]

they come with it.

[paintballrulzs]

no i am gettin it used and the kid lost it

[Gambit1106]

Give them a call and they should help you out
Front office hours:
Monday through Friday, 9:00-11:30 am - 1:00-5:00 pm (Central Time)
Office Telephone: (847) 520-7507
Office Fax: (847) 520-7848

Darren

[paintballrulzs]

thanks

[PyRo]

The PTP ones, I belive are about $40 with the sensor, I'm not sure if you can buy them without it, but if you can that would probably knock it down to about $30. The AGD ones should be pretty cheap, shouldn't be more than $25, but again, I'm not one hundred percent sure.

[paintballrulzs]

It is an agd one. So it shouldn't be more than 25?

[DarkPhoenix]

I do not know about the cost of the mounting plate for the warp feed but here is a possible mod to the plate that you might want to consider... http://www.automags.org/forums/showt...threadid=11992

[paintballrulzs]

thanks

[PyRo]

I don't think it will be more than $25, I would imagine $30 at the most, maybie a shipping fee on top of that. But as I said before, I don't really know.

[paintballrulzs]

well people say tyo make one is that possible if so HOW?

[paintballrulzs]

can u make 1?

[MENACE]

Try starting with 1/4" thick aliminum stock. then the most critical items are the placement of the holes for the screws to connect to the Warp body and the grip frame. I believe the holes are 3/16" drill for 10-32 machine screws.
With this in mind, leave enough space for your hand to fit with the hopper and hose and you should be fine. Make sure to draw out your initial ideas on paper and maybe even cut a sample out of cardboard.
Good Ruck!

God Bless U.S.All!

[paintballrulzs]

k thanks guys. I called today b/c our school has psat's and got out round 11. So i had time to call. Well they r 15. So i am gonna get 1 in a wk or so. once i get the money. thanks a lot guys