I just installed the lvl10 in my minimag. When I use the middle or longest spring I need to turn up my velocity to the point that I cannot use the lock. Any suggestions would be greatly appreciated.
-
-
The only recomendations I can make is to either use the short spring or go with the stock velocity adjuster, which is tournament legal, at least in my interpretation.
"The BEAST"
"No-Rise" E-mag
Level 10 Bolt
AGD Flatline 91cu in/4500psi
Black HALO B
"Red Heatseeker"
Red to Clear Fade Freak Factory Impulse
68/4500psi Max-Flo
Red HALO B
-
Put a shim inside the velocity adjuster. Then the velocity adjuster will sit farther out the back so the tourny lock will fit. Make sure the shim has a hole in ti to vent excess pressure.Except for the Automag in front, its usually the man behind the equipment that counts.Comment
Comment