Ricochet and JMJ Vortex Impeller

Collapse
X
 
  • Time
  • Show
Clear All
new posts
  • sneakyhacker420
    AO's Uber Green Guru
    • Aug 2002
    • 1247

    #1

    Ricochet and JMJ Vortex Impeller

    JMJ products made the votrex impeller for the viewloader revolutions, i have a ricochet AK loader, and i am wondering if one of these impellers would increase feed rate if i bought one and used it

    are there any compadibility issues?

    feed rate increase?

    and any other facts


    thank you

    -sneaky
    Proud Member Of The AO Cesspool Since 08-24-2002
  • spazzed
    AOChamp
    • Jun 2001
    • 4461

    #2
    Good question. If it'll fit, give it a shot. Can't hurt anything ;-)
    I'm way too old for this ****.

    Comment

    • AzrealDarkmoonZ
      Registered User
      • Dec 2001
      • 380

      #3
      Do NOT

      The angles are wrong, I put the impeller on a Ricochet and it was horrible, sometimes it would appear to feed correctly but I noticed at a certain point it would throw the balls away from the feed hole.

      Matt D

      Comment

      • sneakyhacker420
        AO's Uber Green Guru
        • Aug 2002
        • 1247

        #4
        so the stock impeller is better?

        now i am thinking of drilling 2 more holes in the impeller pole thing and putting 2 more weed-wacker lines w/ rubber ends into it.. do you think that it would work better then?
        Proud Member Of The AO Cesspool Since 08-24-2002

        Comment

        • TheJester
          Registered User
          • Sep 2002
          • 753

          #5
          i don't think it would i have the 2k, and i've made some personal mods to it too such as a vibrating reload alarm, but if you put more "blades" in there i think the timing would be off, and the extra "blades" would end up blocking hte feed port, cause i don't know about yours, but mine are positioned that the blades are never over the feed port blocking it, but hey, if you can get it so it won't block it, hell do it up
          AIM- TheJester493 IM me some time

          take a look at my minimag ....
          http://www.automags.org/forums/showt...threadid=64837

          Comment

          Working...