can you guys give me some help on how to make my sfl emag (with level 10) be softer on paint?
thanx a lot, i will just do a search to find all my answers.
thanx a lot, i will just do a search to find all my answers.
-
Last edited by aint_got_no_nubbinz; 11-06-2002, 09:14 PM. -
Yes.
First off, This is a technical question - - and is more likely to be answered in the tech forum.
Second, It is possible for the lvl 10 to be set up such that its actually 'too' easy on paint- - - in that if the bolt even feels the resistance of a ball sitting fully in the chamber, it will stop and re-cock.
Third, ALL this information has been answered somewhere in the neighborhood of a hundred or so times. Read throught the official lvl 10 threads first, then do a thread search for 'lvl 10'. Trust me, all the info is out there.
Fourth, BEFORE you post a question like this, read through this: http://www.automags.org/forums/showt...threadid=53729 we need MUCH more information on your gun/ current levl 10 settings before we can help you.
Finally, I see that you're relativly new here on AO. Welcome!. Also, dont' take it personal if some others jump on you a bit over the 3 things I pointed out to you above. Several of the folks here are a bit 'search happy'. Hope this gets you started in the right direction. If you cant' seem to figure things out after looking through the info already out there, please post a more detailed question in the tech forum, and I / we will be glad to help you.
Once again,
Welcome to AO
Carl -
ahhh. . . I did it anyway. . .
here, read all of this. Check out the install video in the first thread, too.
and finally, this is a pretty huge thread, but TONS of info.
Comment
-
You are such a sweetie Carl.....Comment
-
and to think; I was going to tell him to stuff some foam rubber in the chamber.
HA!
Fz.Fuzzy
Capt. FM O'Lary.
Executive Officer,
Team Wildfire.
http://www.canopy.net/wildfireComment
Comment