hyperframe problems

[nigels_world]

ok heres my setup.....
68 automag hopper left power feed
ans 10 hole bolt
shocktech reg
hyperframe
pmi ceramic barrel

ok now the problems
it works fine when im using my benchy trigger but i cant get the hyperframe to work. ive tried moving the selonoid, changing on off pins (stock, center flag, r/t) and on off assemblies stock and r/t. but when i gass up it will..... leak down the barrel, or go full auto, or nothing at all.

ps any one want to buy a hyper frame? =)

[pbzmag]

I have the HF and it went fullauto on me. Why it happened, I forgot to install the sear. Make sure that the sear is installed without the trigger rod. Don't use the stock on/off pin and bottom. The pin has a larger area thus creating more friction. Without a lvl 10 bolt, the setting for the HF is fine on 7. To get to the service mode, turn the HF off. Press and hold the power button, then press and hold the other button till 0211 is displayed. If done correctly the readout should display 05 07. 07 is the default setting but can be changed to 3-9.

[nigels_world]

my sear is installed corectly. when i turn on theframe it reads 0130.... not 0220 or whatever yours reads. and in service mode i have tried 3-9 all to now avail. in the lower settings it dosent have enuf nuts to kick the sear. and in nine it work but now it will shoot once and then the bolt sticks out and wont go back unless you push it back in. it has a new bolt spring and bumper.

[pbzmag]

I have read on other threads that some people needed a longer pin. You may be one of them. Call or email Centerflag about your problem.