RT + Co2= ?

[smilestyler]

I am looking at buying a used RT original. Will it's inteliframe fit my micromag? For the times when I am reduced to C02, can I slide in my Micromag/68 classic valve? Is $500 too much for this gun with Lvl 10, and intelliframe?

[Bulldog]

I'll try and answer as best as I can.

Will it's inteliframe fit my micromag?

Yes, it should.

For the times when I am reduced to C02, can I slide in my Micromag/68 classic valve?

I assume your talking about putting the classic valve on the RT rail/body. If it's an early RT, no I don't think so, if I read your question right.

Is $500 too much for this gun with Lvl 10, and intelliframe?

Mags are great used because of their durability, but I've seen used Emags for 600. A new RT Pro with intelliframe goes for about 575 if you shop around. You can make your own decision from there if it's worth it.

Hope that helps.

[Bulldog]

Another thing to consider...You could do the "go retro" program for 200 bucks. That gets you the rt valve. Buy a level 10 kit for 80 bucks, and a new intellframe for 115. And put it all on your current micro mag body for only about 400 bucks. That gets you the same parts as an RT, but without all the weight, and in a snazzy looking package too. Plus you get to use autococker threaded barrels instead of twist lock. (I think AGD products are great, but I've never really liked the twistlock). Just something to consider...that's actually the same setup I run.

Make sure when you order your inteliframe you tell AGD it's for a Micro.

[spazzed]

To answer your questions:

I don't believe the I-frame will fit. Why else would they sell one only for RT's? (In the online store).

Not sure on the 2nd one

Little bit high if you ask me. If you're gonna play that much, just go w/ an RTPro.

[Bulldog]

When I bought my micro body from PTP, Tracy from PTP, told me that you have to use the I frame for the RT Pro on the Micro. I assume she knows what she's talking about. I sent the body to AGD to put an I frame on it. I told them what PTP told me and I assume they put the RT version on it.

[toymyster]

If it's an original RT, the Iframe will not fit any other marker, since the rearmost hole is larger to accomidate the banjo bolt of the RT!! Also, the classic valve will not fit in the RT rail, since the RT valve's air input is thru the banjo bolt that serves as the field strip screw!! As for weather it's a good deal, there are too many variables!! If you are looking for something you can switch parts back and forth with your micro, you'd probably be better off with an RT Pro instead!!Hope this helps!!

[Xzion]

Classic RT frames will fit Auto/Mini/RT PRO mags, I know, since I have a classic RT Z-Grip on my ReTro Minimag. AGD made some spacers to fill the larger Classic RT hole.

Aside from the larger hole for the Banjo Bolt, all the frames are the same. Perhaps you could give AGD a call and see if they have any spacers left.

If you want to go swapping valves and grip frames between an RT and Auto/Mini mags, you might want to look into an RT PRO. They come stock with Intelliframes, and use the regular mag field strip screw. plus the two valves are interchangeable. just pop one out, and the other in. You may need to fine tune the spacer in each valve when swapping the two valves back and fourth.