qwik Emag question for the tech(s)

[50 cal]

Just got my Emag and played with it this weekend. Works fantastic! Got lots of compliments on it. Thanks Kayle!

But, the Emag came with a jumper cable of sorts. Is this to run the warp off the Emag battery? I see where the warp has a female connection on the bottom of the part where the side panel opens. I take it this is where it connects. So the real question is: Where under the grip panel does the connector go? There are 2 connections that it can fit.

Thanks mods.

[donggie]

BE CAREFUL

USE ONLY THE MIDDLE ONE. THE ONE CLOSEST THE CENTER OF THE GUN!!!!!!! DO NOT USE THE ONE AT THE TOP. I BLEW UP MY WARP THAT WAY. ALTHOUGH I WAS TOLD THAT IT WOULDN'T AND THERE'S ONLY ONE PLACE IT COULD FIT, AS YOU SAID... THERE ARE TWO. USE ONLY THE ONE NEAR THE CENTER OF THE GRIPFRAME.

HATE TO SEE A REPEAT PERFORMANCE.

Don

[Russ]

Check out the pics from AGD's site...

http://www.airgun.com/emagtechpix.html

Like donggie says, it's the one in the middle of the board.

[50 cal]

Thanks guys I appreciate it.

[HeerophantG]

i think the one on the above can't really fit the interface
there 's only one in the middle that can fit into it.