Need help qwik!

[50 cal]

Stripping my E-mag to be annoed.
Can't get the sear apart from the soleniod. Got everything else, just can't get the sear and soleniod out.

Thanks.

[snakestang]

You need to remove the C-Clip that is attached to the plunger. It is located just above the selenoid and it is pushed into a little slot. Just pull on it with some needle nose pliers and it will pop right out. To take out the selenoid all you have to do is remove the set screw on the right side behind the grip. It will fall right out.

[50 cal]

Thanks....I didn't know if the C-clip held anything else intot the solenoid or not. It looked like it was the key to removing it all but I wasn't sure.

Thanks again.

[snakestang]

I see you got it but follow the tip of the pen and you will see the groove. Glad to help.

[50 cal]

I saw the C clip and the groove. Just wasn't exactly sure that clip didn't hold anything else into the solenoid.

Thanks again for the help snakestang.

[toymyster]

Remember 50Cal, this is an AGD product!! If something is in there, it has a function!!! Don't forget to post pics after you're done!!!