911 Powertube o-ring!!!!!!!!!!!!!

[Greg711]

How do you get a replacment on the powertube tip? I been trying for an hour, my fingers hurt really bad. Whats the trick, is there an easier way to do this?

[minion450]

for the o-ring use a small pick, or a piece of wire. or if its the power tube use a quarter to twist it off.

[Greg711]

Still haven't gotten it on. This is a part I never want to replace ever again! Anybody else have any info on how to easily put the o-ring on the power tube tip? Anything you guys I want to hear it. Im desperate.

[minion450]

OH to put it on. put the o-ring on the table and push the powertube on to it. You should be able to push it in this way.

[anthraxxx]

where did you get the o ring for the power tube tip? word of caution, i got the bright idea to replace everything on my mag with my brand new agd parts kits, including the power tube o ring. then all the sudden i started noticing the tip becoming loose when i removed the valve to clean the marker. this caused me to check after every game, where i discovered this was a reoccuring thing, the tip would become loose. turns out the tube tip o ring is unique and one does not come in the parts kit. the oring that seats the bolt does but not the one that goes around the tube tip. had to send away for one and then everything was normal again.

[Greg711]

I did get the O-ring from the parts kit. I thought by looking at the website that it was the same oring that goes in side the on/off valve and bottom part of the powertube. I try to order a few if this is the case.