Adding an Eye to a mag

[hostage]

hey, I am thinking about adding a WAS board to one of my mags and adding an eye to it, if the was board can go in. I was thinking about drilling a hole in the barrel and down threw the stainless steel and below that would be the eye? Any better ideas? I want it to be out of the way. or does it have to come from the side...hmmm...
-Doron

[Skeetmaster]

Hi.
Unless is your E-Mag, Why?
If it is your E-Mag, AGD do the ACE anti chop eye.
Gaz

[hostage]

I have a booyaah that has been modified, i could put the sensors on both sides and make an eyecover for it or something.
-Doron

[EsPo]

i think your gun is wierd enough already... you need to stop..... now

[Havoc_online]

just get a level 10. everyone knows that works. eyes get dirty and go through a lot of other problems.

[hostage]

Havoc, I already have one, you should know that. I am bored and want to add to my marker.
-Doron

[Brak]

if you want to do something new with your gun, paint it pretty colors

[boomerfoxtrot]

I have a LX EMAG... will AGD do the ACE eye if I send it in with cash?

[mykroft]

IIRC you need to go to the Xtreme body to get the ACE, it has no where to mount in the steel body.

[TheJester]

no drilling of barrels, i was gonna port my stock barrel, but think about it...unless you have the means (which i do) you would have to hone the hell out of it to get the burr out of the barrel, changeing the inner diameter of the barrle, changeing your paint match. So you would entirly have to re do the whole inside the barrel (not just where you drilled) to make it even, and it would be hard to make it even, so i don't think drilling would be a good idea, just cause it sounds a little to much of a hassel for the worth, i would find something else to do, you like to tinker, so do i, what i did to tinker, i wired a vibating reload alarm from my ricochet 2k into my grips