im thinking about getting a warp feed and a new pf body soon on my automag classic. i want my setup to look like the one on the top of this page http://www.airgun.com/EMAG.html except my gun is obviously going to be a mag classic instead of an emag. right now i have a standard feed body and im going to buy a new body so what kind would i need? a hr pf? or some kind of special warp feed body? and when i do buy the warp should i get a proteam or an agd? and one last thing, where does the mounting bracket on the warp go? thanks
-
I'll see you in the center. -
warp body
Well the warp plate attatches to the bottom of you gripframe...between the drop and the frame. If you are right handed, the ultimate setup is a warp left body. If you are lefty, go for the warp right. A powerfeed body will work just fine too, but reverse the terms. Right handed-powerfeed right. And get the AGD Warp...It comes with everything you need to hook it up to the Mag, with any body. Hope this helps. -
i can order the warp body directly from agd, right? do you know how much it should cost? and will i be able to use the warp body without the warp feed on it (just incase i get an emag and put the warp feed on that)?I'll see you in the center.Comment
-
warp body
I assume you can get them directly from AGD, but I would "support my local store", and contact Robert at Pev's. He will surely hook you up. And if you are planning to use a hopper at all, the get the powerfeed body.Comment
Comment