Two questions for you all. Does anyone else have trouble getting the valve to slide in along the body straight? As it is, most of the time mine gets jammed and I have to take the body off the rail. On a different topic, if you use microlines, do you have trouble with the lines leaking? I can get it to stop after bending them abit but it is annoying. These are just two problems that are more annoyances than anything but I figured I would at least make the minimal effort to maybe take a little less annoyance out. Thanks
-
"THIS.....is my BOOMSTICK!!" -
The screw near the trigger may be to tight. Adjust the screw till your valve slides easily out of the body. Another reason may be because the on/off pin is in the open position. You need to pull your trigger to put it in the closed position. Make sure that you degas your marker first. As for the microline, that is the bad side of using that type of air link. You just need to replace it after awhile. -
You do know you're supposed to turn the valve, right?
As for the micro.... You'd be better off using the stuff to pick boogers out of random people's noses. (Atleast in my experience, I got bored one day
).. Dump the stuff and go w/ macro or SS. Micro'll starve the crap out of the valve. Again, my experience
I'm way too old for this ****.Comment
Comment