ok, heres the deal

[AutomagN2]

Everyone knows about my gun pressure dropping to the 0 psi and stuff liek that on my previous post.

I took my valve off, i popped it out, un screwed it, and looked at the reg seat. The reg seat was worn signifigantly, i will replace it.

Another tough thing i have to ask is, when i screw my nitro tank in, as the gun pressureizes, it shoots once, is this normal? Whats causing it to do that?

[EsPo]

i have never expierienced(i suck at spelling) a gun shooting when it gasses up, that if quite odd. It is a good idea to hold the trigger when gassing up the gun.

[Gotcha3]

About the gun shooting when you gas it up...

Hmmm, that is odd. Sounds like it is probably your sear (check to make sure that it is not worn) Also, check your on/off assembly.
Hope this helps,
Aaron

[Bulldog]

I have experienced that, on two seperate guns, and I have absoloutly no idea what causes it.

[AutomagN2]

I'm going to order a new reg seat since its worn all wierd.

[spazzed]

I'd recommend a new sear too.

[toymyster]

I have seen that happen on Retro Valves, just clean and oil your on/off real well!!

[AutomagN2]

On off valve on my tank? cause i don't have one, its screw in, pressurize and go. My tank output pressure is horrible, i have a regulator on my gun and i don't need it cause the gun has one itselft.

[Kevmaster]

he means the on-off pin on the mag. its the thing that the sear engages. when you pull the valve out, its got a little brass(on the RT, alum on the classic) head that pops out with a pin inside of it

[AutomagN2]

ooo so i could be like stuck? and then pop out. ok i'll slick it up.

[Kevmaster]

define "slick it up"

just make sure theres no gunk in there and put a drop of paintball oil on it....

[AutomagN2]

heh, i was just gonna put a drop on. Thanks everyone.