Warpfeed Intellifeed input problem

[ben_JD]

It appears that my Intellifeed input receptacle (the 2.5mm female connector on the Warp circuit board) is no longer working. The intellifeed cable from my Intelliframe is working (I confirmed with the use of a multimeter. When the switch in the Intelliframe is open, infinite ohms, when closed, the ohms meter "maxes" out).

Is it likely that the intellifeed input receptacle is bad by that the Warpfeed still works normally on the vibrate mode (though not as well as when intellifeed cable is installed)?

[Havoc_online]

Are you sure you have the right jumper settings?

Are you going to the Houston AO meet? I could look at it there.

[ben_JD]

I haven't changed the jumper settings from back when it actually worked, though I will check.

I am not going to Houston AO meet, but will post back when I have checked the jumpers.

[Havoc_online]

on the right set of jumpers remove the bottom jumper and use it....

Ifeeding from an Emag use the mid jumper

Ifeeding from Iframe, use the top jumper

[ben_JD]

That is what happened! About a month ago, I forgot my intellifeed wire at home and changed the jumpers on the field so that the vibration sensor would operate. I forgot to change the jumpers back.

It works now; thank you for the memory jog.