Can i do the intellie setup on other frame other than the intelliframe from AGD? I lloks farily simple did not know if anyone has given it a try or not
-
ehh.. theres a 32* grip frame? anyway, it is pretty much possible with any frame, but most require lots of work, and prolly some soldering. somebody did it on a stock mag frame, but i cant remember who it was.
btw, instead of using [image] in your sig, use [img] -
yea they make a 32* one. It was Chrome for $40 looks just like the dye trigger frame! So i said why not. I work as an automotive tech. soo i am pretty sure i could pull this off
and thanks for the tip on the image thingComment
-
ive done it
i intellifeed my dye frame it wasnt that hard i just used twit ties to hold it on and it works good it took like 4 hours though because i kept cutting wires to short. i'll have to get pics soonE-Mail: [email protected]Comment
-
Like they were saying, you could do it on just about any frame.... but the Intelliframe is setup to be used w/ the radio shack parts ... so they all fit together JUST right, without any soldering (unless you wanna solder the connections but thats optional) ...
Your just gonna have to do some tuggin' and pulling but it should work ... but I'd stay w/ the recommended parts for the Intelliframe, its only 4 parts (roller switch, cable, screws/nuts) and its very simple to wire together, just mounting its gonna be your pain ...
Best of luck though man ...
Sincerely,
DaveIts a wakeup call for the Nintendo generation
GregHastingsPaintball 3 is comingComment
-
well from what i hear it is all in the mounting. they all have the center bar. i would just have to line up the switch with the sear in the frame. that way i know where it will hit and mark it. and drill. or maybe make some slots soo that i can adjust it.
ANYONE KNOW WHERE TO GET A CHROME SINGLE TRIGGER FOR MY CLASSIC MAG?Comment
Comment