ok i am making my z-grip intellifeed. and i have came across the problem that i can not put my sear all the way in. cause the micro switch is in the way. i would be really great full if some one can help me.
-
Use a table to get it smaller in over all hight
-
looks like you'll have to move the switch...not much else you can do. if you feel like you screwed it up, i guess all i can say it tough luck. -
-
mount
i used electral tape to wrap around it. i have the switth all the way back. well i think my wires are to big causing the sear to to go down al the way.Use a table to get it smaller in over all hight
Comment
-
if you havnt seen this already, its a rather old post about the same thing, includes instructions more or less. hope it helps!
Comment
-
got it
ok i got it mounted, and it works like a dream. thanks for all of your help.Use a table to get it smaller in over all hight
Comment
Comment