Ok, I'm swapping all my Emag parts from the stock body to all new ULE parts. The only part I'm having a problem with is the one Battery contact under the rail of the grip frame. One has a screw, and one is just set in there tightly. This is the one I have to get out. Thanks guys!
-
WE ARE DEADCELL, AND WE WILL RUN THROUGH YOU
Dayspring - "We've had Clare at Shatnerball." "I'm confident that she can take 20 guys."
"I'd trade my cocker for some steady pu**y" -
I think you have to punch it out with a stick or something.
One question where can you get the ULE grip frame from i only see the ULE body rail in the AGD store.Last edited by 56kSomeGuy; 12-20-2002, 01:35 PM.set up: Micro e-mag with 32 degree chrome flame drop, Level 10, 88/4500 crossfire, 12 in CP, 32 degree whisper and ARADUS 14in barrel, EVO II.
Stare at Mr. Humpey!!Stare at Mr. Humpey!!
-
I got it from TunaMan. Theres a thread about the ULE parts. Thers a lot of info about it there.WE ARE DEADCELL, AND WE WILL RUN THROUGH YOU
Dayspring - "We've had Clare at Shatnerball." "I'm confident that she can take 20 guys."
"I'd trade my cocker for some steady pu**y"Comment
-
You have to punch it out with a drift pin punch, then press it back in. Its all in the email I sent you. Good luck with that safety assembly. Tom done it real good this time!
Comment
-
Thanks Tuna. The drift pin worked perfctly. I was able to punch it out pretty easily. Putting it into the new grip was ok too. I wrapped the grip frame for padding, then just pressed the pin in with a vise.WE ARE DEADCELL, AND WE WILL RUN THROUGH YOU
Dayspring - "We've had Clare at Shatnerball." "I'm confident that she can take 20 guys."
"I'd trade my cocker for some steady pu**y"Comment
Comment