E-mag battery question

[freek133]

When the battery is hooked up to my gun, the led screen says "low battery" or something of that sort indicating low battery. So I go to put it on charge, and the light is green supposedly indicating that the battery is in trickle mode and is ready for use...

I put the battery back on the gun, and E-mode will not work and the led screen still indicates low battery...

So I put it back on charge and still have a green light,

Should I just keep it on charge? Or what?

[toymyster]

Sounds like your battery is no longer accepting a charge!!! In other words, dead battery!! However, do check all battery contacts for corrosion and things like that!! Hope this helps!

[freek133]

Great, just great!

I get my gun, use it for two days of play, and now I have to buy something else!...

[hitech]

Some of the chargers change to the green light too early. Leave it plugged in over night and you should be fine.

[athomas]

Plug the battery into the charger and then plug the charger into the 12v outlet. Even if the indicator shows a green, leave it to charge the battery for a few hours.

[Kevmaster]

yeh, charge it and leave it in for 5-6 hours or overnight. then see if it doesnt work

[freek133]

Guys, the problem never quit...

I tried charging over night(3 times actually) and nothing... after putting it back on my emag to see if a light in the charger failed I put it back on charge and the light turned red, I thought I was getting somewhere,

Well, after another overnight charge the light didnt change from red, and the emag still showed "lo battery"

So I took it out to the car today and drove around for two + hours to see if it would charge from the car, but to no avail it still hasnt charged...

What is the problem? Do I need a new battery, or do I need a new charger? HELP ANYBODY, OR TOM!

[Havoc_online]

sounds like a bad battery. it happens.

[freek133]

thank you very much havoc, could I ask how sure you are that its a bad battery?

because if its not then thats 40 dollars down the drain, and Im a little low on funds due to the up and coming tourney season.

[BlackVCG]

Here's what you need to do.

Take a digital multimeter (you can get really cheap ones at Radio Shack) and read the voltage of the battery. It should be 16-19V. If it's less than this, then the battery is not accepting a charge and is dead.

Call AGD Tech Support and tell them everything you've told us and see what they can do for you. Do this before you buy a new battery from the store.

[hobbesTZ]

I'm having the same problem :-(

Atleast my gun is new, so I can take it in. I'm gonna try leaving it in overnight.

[tat2dhillbilly]

question for those in the know..

I have an extensive collection of rc car batteries and chargers and discharger equipment. I can rig up a connection to do a hi amp hour discharge of the battery and then do a full hi amp charge follwed by a trickle. This is used to wipe out the "memory" in rc car nicads. Would this work with the e-mag battery? This will generate some heat ,about 100 deg F I should think, will this damage any components?

[sniper1rfa]

no, it probably wont work, and yes, it will probably damage the battery. a NiCad charger will not be able to "see" the voltage drop of a NiMH battery that indicates a full charge, as it is very small when compared with a NiCad. in other words, it will overcharge, which is REALLY bad for batteries.

[crazyray]

ok i have the answer for you

I too had the same problem. thought it was the battery so i sent it to AGD with the charger. They tested it found it to be nothing wrong so they sent it back. Went out to do a practice and found it doing the same thing again. So This time I sent the emag and battery and charger back. Found it to be the pc board the selenoid was kinda bent. How I have no idea. Works find now.