Banjo bolt RT problem

[Brak]

well i was dry firing REALLY fast today, and my body practically came off of my rail and my gun started leaking like hell. i disconnected my air source and i screwed my banjo bolt back in. problem solved. but then i start dry firing again and the body gets loose again! its just really annoying, and im afraid when i play this will happen and ill be screwed.

[BajaBoy]

i have only shot an "rt" never took one apart but know some stuff about em.

do u have that lil rubber/urathane (sp?) washer between the bolt n rail?

[toymyster]

Check your front grip frame screw for tightness, or if it's there at all, that is the allen screw right in front of your trigger!! Hope this helps!!

[Brak]

my grip frame screw is fine, but that is only holding the grip fram onto the body rail. the banjo bolt is the only thing holdint my body onto my rail, and it keeps getting loose

[BlackVCG]

Banjo bolts don't have a urethane washer. They have the three o-rings that provide a friction fit.

Are you tightening it with an allen wrench? If not, that's all you need to do and it will be fine. If so and it's still coming loose, then replace the o-rings on the bolt and it be sure to tighten it with an allen wrench and it will be fine.

[Brak]

Thanks, i tightened the banjo bolt with an allen wrench, but since its stripped i didnt tighten it too much. im sure i dont need to take it apart anytime soon, but if i do have to i think i might have trouble. but for not im gonna do a hell of a lot of dry firing and see if its tight enough. if it still isnt tight, is it ok to loctite my banjo bolt? if not i guess i gotta buy a new one.

[primetime]

Hey I have a extra bolt, if you cant find one.

[Brak]

primetime is it a banjo bolt? if it is and its in good condition i might have to get it because i dont want any more trouble with mine

[primetime]

Yes it is, and it is in good condition. I wont be back home till the 31st. I will get back to you then and send it out. If you can email me your address. Thanks.

[toymyster]

Brak, the body on the RT is held in just like other 'mags, the fact that you say front grip frame screw does not hold the body in place bothers me!!! Are you sure the front grip frame screw is not holding down your body, because it has to and if it's not, there is a problem!!

[primetime]

Also if you need another body rail for a old school rt I have one too. Just in case yours might be messed up.

[cheetah256]

i have a classic RT too, and the grip frame screw does hold the body on...

[Brak]

you mean your grip frame screw (the one above the trigger holds you BODY onto your rail?

[toymyster]

That's exactly what we mean!!! Sounds like you found your problem!!!

[Brak]

so let me get this straight. my grip fram screw (the one above the trigger, and i have to put my allen wrench through the trigger gaurd's hole to screw in/out) is supposed to go through my trigger frame, through my body rail, and into my body? mine only goes through my grip frame and into the nut that is in my body rail