Problems with my mag

[mosskeet]

I bought a 68automag classic about 5 months ago and just now tried it. It has the intelliframe with revvy hopper. I'm running HPA. If i pull the trigger back all the way it fires clean and I can hold there and it won't leak. When I let it go, sometimes the trigger wont reset all the way and pop back the the gun will just leak air until i pull it again until it resets. Also sometimes when letting the trigger go it will fire again really quickly. Any ideas on my problem here? I might be able to upload a video of what its doing a little later in the week.

[toymyster]

This one is a classic, all you need to do is take the valve apart and make sure everything is cleaned and well oiled!! If you bought your 'mag used, I highly recommend getting a parts kit and replacing all of the seals in your valve, that will take care of it!! Hope this helps!!

[mosskeet]

ok, thanks, ill take your advice and do this tomorrow

[IcantBelieveit]

also if it has the lx you may need to turn up the velocity slightly

[mosskeet]

I tried adjusting velocity before and that didnt help. I'm gonna check out the valve and replace rings and oil it tomorrow.