when i got my warp feed i was very pleased with it, but a few weeks later it started giving me problems, the main problem being that when i fire the warp will not spin 50% of the time and that is with the sensor turned to the most sensitive setting. i mean i have spent hours trying to fix it and i need your help my gun is a automag classic. please help me!
-
----------------------------------------
"mags, making the world a better place one cocker at a time" -
take the black panel off and check if the rubber band is too loose, that shoudl be a fairly tensioned band between the motor spindle thingy and the disc splindle thingyamaboober -
Do you have Level 10? If so, look into intellifeeding it. Level 10 is a low recoil setup, so to get the best reliability with your Warp, you need to I-Feed.
You can also make sure that your mounting screws are fully tightened to transfer the vibrations from the grip frame to the Warp. Also, are you using the same battery as the week before? If so, did you leave it connected to the Warp battery connector since then? If so, the battery is probably drained and needs a replacement. Use high quality batteries like Duracell Ultra's or Plainview 9.6V NiMH Rechargeables.Comment
-
it does not have a level ten and the rubber band in it is tight. i can dry fire the gun and the warp runs fine but when i get to the field and put balls in it and start playing it will start messin up.----------------------------------------
"mags, making the world a better place one cocker at a time"Comment
Comment