my new used RT

[impulse666]

I just got a used RT a week ago from pro paintball (Team Lockout). I took it up to get some air. They ended up doing work on it. I took it home, gassed it up, air started slowly leaking up thruogh the power feed. Also the gun wouldn't go reactive. I just fired like a normal mag. I am using compressd air and the pmi thor reg's output and the guns velosity should be fine. What should I do.

Freeflow cocker
Impy
Broken RT
freek
68/4500

[BlackVCG]

Pull and hold the trigger with the gun gassed up. Does the leak stop? If so, then you need to switch to a shorter powertube spacer (If the gun has the Level 7 Configuration) or you need to replace the powertube o-ring (o-ring below the spacer).

Reactivity is controlled by output pressure. Check the output pressure of your Thor Reg with an output pressure checker. Also, do you have dial calipers? If so, measure the on/off pin length and let me know what it comes out to be.

[impulse666]

Blackvcg, I fogot that I have a level 10 in my RT!

[BlackVCG]

Switch the carrier o-ring to one size smaller. Less lines means one full size smaller and three dots indicates a half size. If that doesn't stop the leak, then remove all the shims and then try it.