POS Slide checks

Collapse
X
Collapse
 
  • Page of 1
  • Time
  • Show
Clear All
new posts
Previous template Next
  • spawnboy
    Wang Spawner
    • Nov 2001
    • 396
    #1

    POS Slide checks

    What can be done about these probmatic pieces of hardward that IMO are POS. I can't leave my tank full with out all my air slowly leaking out. Any suggestions?

    spawner
    Cyprinus carpio amour

    Spawners feedback
    Good Traders n' Sellers
    Tunaman, CoFFeY[Nitro], Stupi, RaV3n_Pa1ntba||,Potatoeboy, irbodden, paintballbeaver, drummr6, r_malloy, CaliWagon31, kilaueakid, thatguy68, PB700, GrassNinja.

    Bad List!!!
    Shamu
    Tags: None
    • Load SM5
      Scruffy Administrator

      • Oct 2000
      • 6772
      #2
      A pro-connect is about the best one out there. I would'nt trust the other ones except to vent the line pressure after you turn the tank off.


      Moorewatch

      If you read this, thank a teacher.
      If you read this in English, thank a soldier.

        Comment

        • Brak
          POOP
          • Sep 2002
          • 1996
          #3
          yeah just spend some extra money and buy a proconnect
          SIG RULES SUCK REAL BAD AND THEYRE STUPID AND DUMB AND THEY STINK AND ARE STUPID AND I HATE THEM AND THEY SUCK REAL BAD

            Comment

            • sneakyhacker420
              AO's Uber Green Guru
              • Aug 2002
              • 1247
              #4
              get a pro-connect

              or you can take apart the slidecheck and wipe all the parts down with oil and replace the o-rings inside (usually POS buna o-rings) with the good urethane ones and oil it up good, then put it back together


              that works for me and my slide check
              Proud Member Of The AO Cesspool Since 08-24-2002

                Comment

                Previous template Next
                Working...