Level10 Help!!! Yet Another Question !!!

[SingleShotGabe]

I have a problem with Air Leaking down the Barrel...So from what I read I went ahead and tried ALL Carrier sizes...I get Air leaks with certain Carrier's and with others I have no leaks but then when I pull the trigger It won't shoot...I was using the Medium sized spring and two shims. Any help would be great !!!

Also heres a carrier question...How do you guys determine the size's of the Carrier's? there's no number showing me which is smaller than the other nor does one look smaller than another...the only thing I see different from them all is that some have lines on them...Look at the attached picture...


Here's my setup
Retro Valve
Intelliframe
Classic Body
Freak Barrel System
Gas-Thru Grip
P.M.I. T.H.R.O. Female Regulator

[SingleShotGabe]

heres a picture of my rig

[BareBack]

Gabe, the carriers are graded in size according to the lines and dots on the carrier, the more lines, the tighter the carrier i.e. 1 line; 1 line/1 dot; etc, etc It should be a snug fit over the inside pin of the bolt. check this by puching the o-ring end first onto the pin, if it goes on real easily, it's too big. it has to be a snug fit.

Once you have it back together properly, try firing, if it won;t fire, turn the velocity up til it does. Then Chrony the marker, if it's too hot, then turn it down til it;s safe, or if it doesn;t fire, go to the next main spring down (shorter)


If all else fails, the installation instructions should be on here somewhere I think, can't remember where I got mine from.
Hope this helps.