Important How To Guide: Taking Your Mag Apart

[Mr. -RushY-]

How to Dissassemble Your Mag:

Step 1:
First, disconnect the air supply. Unscrew/turn off your tank and unplug the hose going into the valve.

[Mr. -RushY-]

Step 2:

Step 2:
Take out the screw under the Valve. Note: it should not be tightened with an allen key once you put it back together.

[Mr. -RushY-]

Step 3:

Step 3:
Remove the valve from the body. It will not slide straight back out. There is a small pin welded onto the back of the valve and it will take a small amount of twisting the valve to move the pin through the Z-groove. Now the body should look like this:

[Mr. -RushY-]

Step 4:

Step 4:
Valve dissasembly. Clean off all the parts. Put water through the bolt and clean out any paint in the Valve. Oil the spacer:the little ring between the bolt and the part were the air comes out.

[Mr. -RushY-]

Step 5:

Step 5:
Put a squeegie through the body to clean out any paint or dirt.

[Mr. -RushY-]

Step 6:

Step 6:
Take out the power feed plug. If you have standard feed skip this part.

[Mr. -RushY-]

Step 7:

Step 7:
Put a squeegie through the power feed or standard feed to clean off any paint or dirt.

[Mr. -RushY-]

Step 8:

Step 8:
Assemble the Valve in this order:

[Mr. -RushY-]

Step 9:

Step 9:
Put the valve in and push it in all the way.

[Mr. -RushY-]

Step 10:

Step 10:
Use your other hand to screw the screw in Note: Do not tighten with an Allen Key!

[Mr. -RushY-]

Step 11:

Step 11:
Reconnect the Hose to the Valve and put the power feed plug back in and your done! Hope this guide was helpful.

[davej946]

As ESPN would say: "An instant classic!"

BTW, Mr. -Rushy-, you sir should be a hand model!

[SIGSays]

saw that at pbreview.......... nice work (again) lol

[Mr. -RushY-]

up

[alf]

nice job!

way to go rushy!

excellent contribution to the board...

what about part II...valve disassembly?

-alf