Hey guys, I am new to the board and a brand new Automag RT Pro owner. I picked up a Freak stainless rear so that I can use my barrel system but I can't seem to turn it enough for the spring loaded pin to pop into place. Has anybody else had this problem? I also realized after I bought the back that it only has a single ball detent, do you see this as a problem?
-
-
Welcome to the boards...
It won't be nessessarly bad to only have one ball detent in, but if you pick up a parts kit, which I highely suggest you do, there will be on in there for you to put in.
As for the freak not fitting..Perhaps you are not putting it in right? If you are and it still doesn't work I would suggest calling up SP and trade it in. -
I believe the freak backs only have one ball detent. The only barrel I know of with two is the stock Mag barrels from AGD. But I may be wrong. You might want to check your detent pin, perhaps it's worn or loose and needs to be adjusted.My Trader Feedback
It was the only tournament I've been to where they have more cases of beer than paint. - gimpComment
Comment