Stock Cocker Reg

[Minimag4me]

Right now i have a stock cocker reg on my mag and for when i get nitro 1. is this reg high enough flowing to not cause shootdown 2. what psi does this reg regulate to or does it just stabilize gas?

[Cha0tic]

you can run the reg on your mag just fine. i would run it on your mag until you get compressed air. once you have compressed air, you will not need a 3rd regulator.

3 regs= (the reg. in your gun)(reg in your compressed air tank)(cocker reg)

this can cause shootdown at higher rates of fire. i would use the cocker eg with your co2 set up, but not with compressed air.

[Minimag4me]

I know it will probably cause shootdown but if the output pressure is the same as a co2 tank wont it be the same both ways(the flow rate is probably similar too). I think i will run it and if i get noticiable shootdown i will take it off.

[Ityl]

If you have the cocker reg to keep the liquid CO2 out, I would trade it for an expansion chamber. It's choking the system. Also cocker regs aren't very consistent. Running nitro through an x-chamber isn't as restricting as running it through a reg either. I'm sure you could find someone that would trade you a x-chamber for your reg.

[Minimag4me]

When i run co2 through it it is very good at keeping liquid out, much better than an expansion chamber. WHen i had a gas thru grip on it my minimag was having like a 20 fps variation and with it i have like a 3 fps variation so i believe it is very consistant or at least better than a x-chamber. I dont see any choking of the system either.