Trigger frame problems

[Splattered Ham]

I just bought a Benchmark double trigger frame. The problem I'm having is that the trigger rod won't fit inside the grip. The grip seems to small to fit it. Also, the hole for the trigger plunger thing that is what the trigger hits looks too low. The trigger doesn't look like it would hit the plunger unless the lunger stuck out a ways. The hole for the plunger also looks too small. I could get it into the hole but with a tight fit. The hole is threaded for some reason and that makes it harder to get in. Why is this and how can I fix it if I can?

[pbguy888]

I think I may have figured it out. On benchy's there is a place to put a trigger stop. It is threaded. I think that may be where you are trying to put the trigger rod. there is a hole higher than that , that it soppested to go...