I recently took out the guts of my e-mag, board and all, but I can't get the solenoid and sear out. There's a little hex nut that's attaching the two, do I unscrew that to remov them? I haven't been able to use needlenose pliers to get them out, tweezers are too weak, and I can't find a narrow enough crescent wrench to get into the frame. Is there an easier way of going about this?
Oh yeah and during the removal of the board, I accidentally scraped off some of the black coating on the little piece labeled "R1" right next to the "C3" thing.....in the very bottom right part of the board. Is this a problem? I can see some white stuff under the coating.
Oh yeah and during the removal of the board, I accidentally scraped off some of the black coating on the little piece labeled "R1" right next to the "C3" thing.....in the very bottom right part of the board. Is this a problem? I can see some white stuff under the coating.
Comment