Emag Electronics Failure

[ratmage]

I am having a problem with my Emag. When I fire the marker in manual mode everything works fine but when I attempt to fire the marker in electronic mode it does not fire. It does cause my warp to spin, but it does not fire the marker. I took a paintball hit at the top of the battery/grip and some of the paint did get inside on the metal contacts. Once I noticed this I cleaned it but this was about a couple of hours later (didn't notice it until I cleaned the marker after playing). I have charged the battery "to green" and still no luck. I was wondering if anyone has had a similar issue and what they did to resolve it. Especially if I can get a technician from AGD to respond I would be most appreciative but anyone with information would be helpful. Thanks

[Schnitzel]

can you get power? does it turn on?

[digitard]

It is water based, it is possible that it caused a short ... Contact AGD directly tomorrow by phone and they should be able to setup a chance to check it out for you.

Sincerely,
Dave K