question(s) about emag wiring

[Schnitzel]

im planning on doing some major wiring for my emag/warp/revvy setup.

here's what i have so far:
emag battery (just waiting to be tapped)
warp with interlink cable
12V revvy w/x-board

now i've read and re-read robAGD's instructions, with some help from Toymyster. I want to know if i could have some help with some experienced AO'ers. i have an idea, and need to know if it works.



-power revvy and warp from emag battery, and also intelli-link my revvy.

i was going to do the warp mod as per robAGD's instructions with the voltage regulator and capacitors. i will run the power coming from the emag to the regulator, and split power to the warp and the revvy (again, following rob's instructions). and then i was going to also tap into my interlink cable to the revvy to intellifeed it.

so, is it impossible? ive attached a pic.

[RobAGD]

Yep, thats why in some of the pic on my site you see 4 wires dangling out of the Emag

When you run the link into the Rev you need to isolate the curcit with something like a reed relay and your golden.

Also if your a little creative you can get away with only 3 wires Using a comon ground between the link and power.

-Robert