call me dumb , but I cant figure out how to change the velocity on my x valve...

[pbguy888]

ok I know theres the little hole in the back and everything. And I am putting the correct sized allen wrench. But its like theres nothin to twist. and the allen wrench goes super far into the valve. Help please!

[pbguy888]

This is how far the wrench is acctaully going into the valve.

[pbguy888]

And this is the allen wrench all the way in. And it will not twist... Also when I pull it out theres like blue greese stuff on it...

[fire1811]

just put the allen in the back of the valve and turn
the whole silver part of the valve should turn also
u dont need to turn it much to change ur velocity.

and the grease is from the spring pack that is supposed to be there

so just insert allen then turn.

[fire1811]

oh yeah nice nickers
lol

[pbguy888]

ok got it to turn. but is the allen wrench supposted to be able to go that far in? What do you mean spring pack thats supposted to be there? Am I missing something? thanks

Nickers? where? I got a blanket over my legs... Im in my boxers , didnt think yall would wanna see my legs

[Remington]

I believe the "blue grease" you're referring to is blue loctite. I'm not entirely sure how to get it off but I know it's not nearly as impossible as red loctite. Ask one of the techs, or maybe Tunaman or shartley will know.

[fire1811]

no thats fine the allen will go in pretty far but all u need is enough on the small end just to turn the velocity up, u dont need to jam it in there. and
agd uses a bluish/green grease so thats all that is.
and ur spring pack is in there but the allen will go inbetween them just like its doing.

but like i said just put the allen in just enough so u can turn it.