Intelliframe, RT valve, Level 10

[Klay01]

Ok, I have a pretty sweet gun but my intelliframe isnt here yet.. or my halo b.. its on the way though. now the question i have is .. will my intelliframe shoot way faster than my single trigger benchmark.. i dont have a trigger job. should i try to do a trigger job? if so, where can i find directions. i found one site..

http://www.paintballravi.com/Articles/MagTrigger/mag_trigger_job.html

is that a good site to find out on how to do a trigger job? is there any way to make my trigger more reactive? i have found myself chopping a few balls.. and i have the level 10 installed. could that be my barrel? also, the screw in the trigger area of my automag that holds the automag together.. if i tighten it my barrel doesnt twist in.. if i back off the screw a little it fits in easily.. is that normal?

thanks

[Havoc_online]

The guy who wrote that page doesnt know squat about mags, dont do anything he said.

intelliframe will give you a better shorter more crisp trigger pull over any other mechanical frame for the mag.

If you want to make your valve more reactive, raise your input pressure a bit or what I dont recommend, shorten your on/off pin. If you go too far by doing either, then you wont have a legal trigger pull. My advice is leave it stock and use it for a while, you'll get used to it and fall in Love. dont try and do all the mods you possibly can as soon as you get your marker, then you wont know the difference between anything.

what are your level 10 settings, do you have plastic nubbins? were they barrel breaks of chops? good paint/barrel match?

no that's not normal, it could be the wrong screw or some minor tolerance issue. try sanding a hair off the screw.

And WELCOME TO AO!:) (hang out here, your learn a whole lot more about your marker and in time you'll laugh at that site.)

[Klay01]

ok should i get a new screw for it? ill try sanding a little off.. but would that stop the automag from staying together really well because the screw would be shorter? i dont think it would .. just asking. thanks for the reply.. and would i saw a few movies on intelliframes with halo b hoppers.. the trigger was just bouncing off the guys finger... how could i make my intelliframe trigger bounce off of my finger? thanks for the reply earlier btw again.