"no rise" feedneck conversion

[Barjack420]

I had this I idea to take a "no rise" body and turn it into a normal c/f body. I just ordered a high rise from pbgear.com and getting ready to order the no rise from agd.

Has anybody else done this?

I was thinking I could just polish off the threads on the high rise and get it to fit into the "no rise" that way.

ideas?

[Tunaman]

The high rise IS a normal c/f body. What might you be trying to accomplish? and there are no "Threads" on these bodies...they are welded.

[Barjack420]

I know the no rise bodies aren't threaded. I plan to just polish down the low rise feedneck and try to get the feedneck to fit onto the no rise. I figure since the no rise feed is large enough to just accomodate the loader's neck.

The reason I want to make this body is I dont like the normal agd c/f body. Its feedneck is too tall. So I just plan to make a lowrise body with a slightly better looking feedneck.

[Barjack420]

up!