Trigger job for a classic

[POWMP]

I've got a Classic powerfeed mag and was wondering how to lighten the trigger pull if it's possible.

[la690]

there are possible ways but they are not worth the time trouble or risk of hurting your marker. intell or x-valve are possibilities but that depends on the size of your wallet. a simple double trigger can be put on there if you like those.

[la690]

intell= intelliframe if you didnt know.

[Quackman71]

YOu could buy a new frame..but just hack it, frames cost too much and anyway if you get used to the trigger it will work fine, or are used to it...

[Snake847]

There is 1 way that a trigger mod worked for me. Here is what you do:
1. Take a spring out of a pen that clicks
2. cut that spring in 1/2
3. Put it inside the trigger frame on the pin that is connected to the sear.
4. make sure that the spring is snug and dosnet go out of the frame and touch the actual trigger.
5. If oyou take your time and adjust it so that the pressure of the spring so that the on/off pin does not leak but still having a very light pull.

It tooke me 2 hours to adjust it on my classic mag but I got it to be as light as a hyperframe.

[la690]

hhhmmmm.. thats actually a good idea considering it doesnt involve grinding any parts and it's easy to remove.

[Cryer]

Originally posted by Snake847

3. Put it inside the trigger frame on the pin that is connected to the sear.

You mean the trigger rod?

[Snake847]

yes

[pballguy17]

something i thouhgt of.. is putting thespring under the sear, on the on/off side.. so that the spring pushes up on the on/off.. again not so much that it doesn't leak... but enough that it helps. Bad of this is, u an get shot down, and it's easier to shortstroke