My lvl10 is broken what should I do?

[Snake847]

I tested my lvl10 out on all three of my valves and it always leaks down the barrel. I tried all combintaions of parts but it just dosn't work. How do I get a replacment?

[Dayspring]

Well, have you got it assembled correctly? #2- What setup are you using? Did you use the same oring or a different oring on the carrier for each valve?

[Snake847]

here are all of the guns I tried it on:
#1Classic mag-Tested all parts chenged all o-rings and still got the same old small leak down the barrel.

#2Classic mag-Tested all parts chenged all o-rings and still got the same old small leak down the barrel.

RT mag- Tested all parts chenged all o-rings and still got the same old small leak down the barrel.

ReTro- Tested all parts chenged all o-rings and still got the same old small leak down the barrel.

[nippinout]

Try it this way...

Install the LVL10 but without shims. Shims adjust where the bolt vents off.

Also try pushing the bolt back and see if the venting stops.

[Snake847]

tried that all it does is change the pitch of the leak.

[Pand0ra]

Reduce the size of the Oring carrier, it should solve the problem.

@++

[Havoc_online]

goto AGD and ask them for a replacement bolt.