Level 10 + Hyperframe??

[GhillieGuy]

I have a hyperframe on my mag, i might be geting the level 10 but have heard roomers that it will not work with the hyperframe...Does anyone know anything?

[TuffManJones]

that makes no sense to me why it wouldnt work. they wouldnt seem to effect each other unless a problem is caused with the hyperframe on/off when the bolt bounces off a ball.

[hitech]

I have a working level 10 with a hyperframe. I didn't do anything special. That said, I would suggest not using the long spring. The higher the pressure on the on/off pin the more likely you will have problems.

[Doobie]

I too, have a working Hyper/LVL10. I didn't do anything special either. Mine has worked great and the LVL 10 is a Beta so i've had it for a while now. Best $$ I spent on my 'mag!

[Snertz]

Yep

Yea, its no problem as long as you aren't using the longest spring or doing something with a much higher than normal internal pressure. I found that at the max and "8" setting for the solenoid, it had no problem with a 2.0 carrier and med spring.

My setup for the level 10 was the 1.5 carrier, 2 shims, shortest spring. That worked out nicely, but I need to check the velocity the marker is now shooting.

Feels good to mess with the hyper mode and rip strings out without worries (And I worry a lot , 9v revvy's are def not up to the task)

[felony]

hmm..

ive talked to people before who complain about the hyperframe and what it does to the internals. ive heard it rips the bolt up and all sorts of things?

obviously you guys didnt have any probles.. how about anyone else?

would you suggest an hyperframe or an x-valve

thanks
dan

[thecavemankevin]

i too have a working hyperframe and LX RT valve. However it has developed a slight leak out the back/velocity adjuster. I am going to switch out the hp piston and see if that corrects it.

Other than that it works great!

as for Hyper or X-valve....well weigh it out

The X-Valve:
+lighter weight
+trigger bounce like RT valve is possible
+level 10
-mainly the cost
-plus you already have a valve
-need nitro (no co2)

Hyper:
+killer ROF
+very light trigger pull vs. manual trigger frame
+nitro or co2
+never short stroke again!
-cost....thats about all i can think of

when it comes down to it i would say that if you have a RT valve, then stick with it and get LX and a hyperframe. If you only have a classic valve, then it is a toss up, me personally would still get LX and the hyperframe.

[felony]

i actually already have a lvl 10. so i guess it is x-valve or hyperframe

i also already have intelliframe.. so i could get some cash for that and pick up hyper..

will have to ask around..

you know where i can find one?

thanks
dan

[GhillieGuy]

if i were you i would for sure get the hyper... I just talked to centerflag and they just came out with a new board for the hyper to make it full auto, and instead of 13 shots a second, it's 20 shots per second. the upgrade is around 70 bucks, but they are on backorder...

[hitech]

You also might want to check out this thread:

http://www.automags.org/forums/showthread.php?s=&threadid=64976