hmmm Fry working on making a new rail?
I'd like to see this one!
I'd like to see this one!
-
My Trader Feedback
It was the only tournament I've been to where they have more cases of beer than paint. - gimp -
I'm sure we can come up with a few pics
Comment
-
I've discovered my camera sucks when you get in close :-/
But I just have one question, whats that shiny brass tube thingy?
Comment
-
That's the "rail bushing":
it fits int eh back hole on the rail and fits in the grip frame, the field strip screw fits through the gripframe, through the bushing, through the frame and holds the valve to the rail/gripgrame.Last edited by RamboPreacher; 01-31-2003, 12:24 PM.Thanks, Brent "RamboPreacher" Hoefling, CPPA founder
Here is my user feedback thread. and my online jottings
Comment
-
the green hilight:Thanks, Brent "RamboPreacher" Hoefling, CPPA founder
Here is my user feedback thread. and my online jottings
Comment
-
I have to download one of those full directions to my hard drive so I have it when I do that project.
Resin just came in RP, go to start on all of that stuff now. I should have pics of most tomorrow for you.Comment
-
RP- Thordic was being sarcastic. Note his user title. He sent in his gun because it had problems and the reason was that he was missing the rail bushing.Comment
-
oh -
dummy me
Thanks, Brent "RamboPreacher" Hoefling, CPPA founder
Here is my user feedback thread. and my online jottings
Comment
-
And if you look on the parts diagram the RAIL BUSHING ISN'T LABELED!!!!!
That caused most of my problems...Comment
-
...and I searched for an hour or so looking for that rail bushing. Little did I know there was never one there!
Comment
Comment