Warp Intellifeed setup w/Benchmark 2X frame

[2000Sabre]

Has anyone come up with a good approach to mounting the microswitch and phone plug for an intellifeed setup using a Benchmark frame? I would be interested in seeing any pictures someone might have of this or at least an explanation of how you did it. Also curious to how you determined the proper placement of the switch so that the trigger contacts the switch. Thanks for any help.

[Magsrule3]

I think Tuna had said he could do the conversion if u sent it to him. I know he does them to DYE frames though.

[theraidenproject]

i tried tunaman's warp - dye 2x frame @ top gun a few months ago. It's nice. I would reccomend seeing if he will do it, if you don't do it yourself.

[Eye_pecking_chicken]

I put one on my friends mag

I cut a block of wood that was the same thickness as the grip out, and cut a slot at the top for the switch to slide into. I then cut the end off of 2 nails and stuck them through the holes on the switch to hold it into place. As far as placement is concerned, I just kept trying untill it worked right. I'f you want some pictures I could get you some, but it would take a while.
Hope this helped