out shooting loader

[Deadman]

Hello all I just purchased my first mag a proteam micromag rt with lvl 10 and intelliframe. I have an old VL 2000 18v Shredder and find that i am out shooting the loader is it possible to wire the intelliframe into this hopper or would i be better off getting a new Revolution or Halo loader. I included a pic of the wireing so if possible to wire into intelliframe hopefully someone could explain how. Also i am only getting about 600 shots out of my 68/3000 tank is this normal ?


Thank you

joel

[darklord]

Um don't get a new rev if you have that, get either an eVolution II or a HALO B. As for the intellifeed thing, I'm pretty sure... but not positive. Try using electrical tape instead of sauldering so it's not permanent.

[Kevmaster]

Id get a Eggo II or HALO. I dont know the answer to your question, but i doubt youll outshoot either of those two

[IanC]

Intellifeed

You should give the intellifeed wiring a try,
i'm running it on my mag with an X-board revvy and I can't out shoot it. You may only have a shredder but your effectivly taking control away from the board with intellifeed anyway.

I think the wiring should be the same as for a later VL, red wire to the motor and black to one of the negative battery terminals. Go with the earlier advice and use tape to start with, solder it when your happy.

Try one terminal then the other, the right one will be the faster, i.e. 18v not 9v.

Hope this helps, its certainly a cheaper way to go!!!

Ian

[Paintmanmike]

I'm not running Intellifeed and I find it very hard to outshoot the hopper. I did not like Intellifeed and took it out, I'm not sure how it helps the hopper work faster.

If your MicroMag is a vertical feed this will not help but if its a powerfeed have you checked into the parabolically shaped powerfeed plug? I know someone that did and it worked for him.

[IanC]

not sure how Intellifeed makes hopper work faster

Well, it doesn't much. What it does do is ensure that as long as you are pulling the trigger, the paddle is spinning and loading balls.

Work out how many balls you have in your stack up to the eye. Fire rapidly, like as fast as you can go and see when you get your first miss. If like me your first miss feed was when the last ball from the stack had cleared and the loader had to work, then you need intellifeed.

It improves the loaders response time, I was missing 1 ball in 7, consistantly, now I don't miss one.

Ian

[BEEFYSAUSAGE]

well..

I have used my 18v shredder for years and now ive intelli feeded it to my mag ...works flawlessly..unless your shooting 10- 11 bps constantly realy theres no need for a halo or eggo(or eggoII)do a bit of thinking when your playing if it stops feeding after your stack of balls is gone (5-7 shots)then has the hopper started to go again?.
mine usto do that but now it doesn`t,
the intelli feed absaultly rocks on mine and ill never get rid of it..
Oh and my friends 12v revie wasnt feeding my mates sonic bm2k(there fast)put my 18v and no probs at all..
feeding my mag old school..

[BEEFYSAUSAGE]

oh i forgot

i butchered mine 18v straingt to the motor..no circut board at all ...you can always buy new parts if u wanto go back..

[Deadman]

Thanks for the suggestions all i managed to wire the intellifeed into my shredder and am no longer haveing any problems.

Thanks Again