J&J Edge Barrel and LVL 10

[JBlood]

I have the LVL10 for my RT Pro and it works great; however, I just got The Edge Barrel system from J&J and on the smallest bore (.685) the bolt doesn't fit into the barrel back and it locks up. I contacted J&J and they said they haven't heard of this problem from anyone else, and that it may be a problem with the bolt's diameter. Anyone else have any trouble. Any suggestions?

[Bulldog]

LevelX doesn't fit anyhing smaller than .684, so probably .685 is too close. Does it work with the larger sized inserts?

[JBlood]

Thanks... It's probably just too close. The Edge system works great though. It's light, easy to clean and has the flexibilty to work with most paint. I think I might take the smaller bore to a local shop and have them increase the bore for the bolt, and leave it small in the actual barrel. I didn't even think about the LVL10 not fitting the barrel back. Thanks again!