Is this gun messed up?

[Hafter]

I just bought a Booyah retro mag.
It came with the sear pin off. I put it back on but was wondering if there was any way I could tell if it is faulty since it was removed.
Also, a level 7 onoff was installed on it, I think because it is required to install the booyah. If I buy a intelliframe, I will have to install the sqaure onoff that usually is installed on the retro right? I am told this is what makes the gun reactive.
Also should I look for anything on the gun, (inpaticularly the sear) that might be worn from the Booyah frame?

[pbzmag]

The rod needs to be the right length, just not sure what it suppose to be though. The rod also needs to be placed back on the sear if you plan on getting the intelli. The original Retro on/off should be put back in. The booyah and Hyperframe needed a smaller diameter pin for less friction Look at your bolt to see if there is any wear where the sear catches.

pbzmag

[Hafter]

thx, anyother advice?

[SaS]

the sear pin is removed for installation of the boo-yeah and/or hyperframe... centerflag has instructions on their site, http://www.centerflagproducts.com/se...rautomag.shtml

the hyperframe instructions should be all that you need... since they are the same thing