x-valve and mico body

[BigPballer]

does anyone know if the x-valve will fit into a micromag body without any problems

[ringmasta187]

yes it will fit without a prob

[c sherer]

You *MAY* run into some problems with the bolt actually sticking in the frame of the body. Have read several posts where this is happening on the PTP micro bodys, and even had it happen to a friend.
Solution is easy: simply sand away a bit of the "washer" inside the body of the gun (the piece that seperates the body into two halves, internally).

Do that, and then it will work flawlessly!
CoSh

[BigPballer]

thanks

thanks guys

[Bulldog]

If you have problems getting it to fire, you'll need the shorter on/off pin that PTP uses in the micros. Call 'em up and they'll can send you one for like 15 bux. Or just swap out your old pin from your current micro.