I am thinking about getting a cf body and want to keep my j&j edge kit. so how do i change my t-slot barrels to cf. any help would be appreciated. thanks.
-sebastian
-sebastian
-
-
Drill a dent in the middle of the "T" to provide a stop when the barrel hole is straight up.Except for the Automag in front, its usually the man behind the equipment that counts. -
what type of tool should i use?
-sebastianComment
-
Use a vise to hold the barrel stable and straight. Drill the dent with a drill press. Don't drill too deep, just enough to make an indentation.Except for the Automag in front, its usually the man behind the equipment that counts.Comment
-
make sure the vice isnt too tight, other wise you ll mishape your barrelComment
Comment