Smarts Parts Magic Box

Collapse
X
Collapse
 
  • Page of 1
  • Time
  • Show
Clear All
new posts
Previous template Next
  • Strider
    Thunder Chicken
    • Mar 2002
    • 1562
    #1

    Smarts Parts Magic Box

    Theorize, would it be possible to remove a Magic box from a Mag Valve and plug it up to work properly again?
    Tags: None
    • BlackVCG
      Grubby Owner

      • Oct 2000
      • 4956
      #2
      Yes. Just put in a plug in the hole they drilled in the air chamber and use some thread sealent such as Loctite 545 or 592 on it. Then, run your hose to the original inlet hole and it will work fine.
      My Feedback

        Comment

        • IcantBelieveit
          Registered User
          • Nov 2002
          • 1339
          #3
          yes it is possible i did it. with my old valve. and it is a good idea to take it off. another idea would be to take a micro gauge and stick in it soo you can wath the needle bounce a
          s you shoot
          MY FEEDBACK

            Comment

            • pbzmag
              Registered User
              • Feb 2002
              • 1468
              #4
              What did SP do to make it low pressure? Can someone describe it or have a picture of it? I'd just like to know how they did it.

              pbzmag

                Comment

                • warpfeedmod
                  I came, I saw, I painted.
                  • Jun 2001
                  • 1265
                  #5
                  i don't think they did anything..if I recall it was just a box that attached to the side of the valve.

                  more like an expansion chamber of sorts.
                  My Trader Feedback
                  It was the only tournament I've been to where they have more cases of beer than paint. - gimp

                    Comment

                    Previous template Next
                    Working...