Warp Quality
I had the Warp open the other day to adjust dwell, set for intellifeed and snoop at the board.
I have one problem.
When I interned in the QA-Engineering for my company department I would have to reject the control board for insufficient solder.
Hardly looks like there is any solder fillet at all on the FETs.
Anybody else notice this? Anyone lose any parts from these yet?
I have one problem.
When I interned in the QA-Engineering for my company department I would have to reject the control board for insufficient solder.
Hardly looks like there is any solder fillet at all on the FETs.
Anybody else notice this? Anyone lose any parts from these yet?
